Foundations, Drainage, and Site Considerations Presented by Bernard Ray Tillery, P.E. Amarillo Testing and Engineering
“ The function of a residential foundation is to support the structure. The majority of foundations constructed in Texas c...
Load-bearing values of soils For SI: 1 pound per square foot = 0.0479 kPa. a. When soil tests are required by Section R401...
New Language City of Amarillo amendments to the 2006 IRC <ul><li>“ R401.2 Requirements. Foundation construction shall be ...
The path to design residential foundations
New for 2008 for use with the 2006 IRC
NEW - Foundation Table
Assumptions The Table R403.1(a) is based on the following assumptions and are considered mandatory criteria if application...
Amarillo 2-pour Slab-on-Grade (Typical) Brick Veneer – ISO board at base course
Amarillo 2-pour Slab-on-Grade (Code) Brick Veneer – mortar at base course
Interior Foundation Beam Must be installed at maximum intervals of 20’ and/or under load-bearing walls
2-pour Slab-on-Grade ( Energy Efficient )
Monolithic Slab-on-Grade (Code)
Monolithic Slab-on-Grade ( Energy Efficient )
Typical Crawl Space
Pier Detail
Formed 2-Pour Slab-on-Grade
Fireplace footing
Basements <ul><li>Section R310.1 Amend : Emergency escape and rescue required. </li></ul><ul><li>Exception: (Add to end o...
Trenched Basement - (Inset 6’ minimum)
Formed Basement - (Inset 6’ minimum)
Formed Basement – Exterior foundation includes perimeter drainage system
CMU Basement - (Inset 6’ minimum)
CMU Basement - Exterior foundation includes perimeter drainage system
Accessory Buildings <ul><li>The following foundation details are for free standing, single story less than 10’ wall height...
Slab-on-grade - accessory structure
Treated floor - accessory structure
NON-Treated floor - accessory structure
Questions? Bernard Ray Tillery, P.E. Amarillo Testing and Engineering Thank you
of 29

Prfm Presentation

Panhandle Residential Foundation Manual Presentation
Published on: Mar 4, 2016
Published in: Business      Technology      
Source: www.slideshare.net


Transcripts - Prfm Presentation

  • 1. Foundations, Drainage, and Site Considerations Presented by Bernard Ray Tillery, P.E. Amarillo Testing and Engineering
  • 2. “ The function of a residential foundation is to support the structure. The majority of foundations constructed in Texas consist of shallow, stiffened and reinforced slab-on-ground foundations. Many are placed on expansive clays and/or fills. Foundations placed on expansive clays and/or fills have an increased potential for movement and resulting distress. National building codes have general guidelines, which may not be sufficient for the soil conditions and construction methods in the State of Texas. The purpose of this document is to present recommended practice for the design of residential foundations to augment current building codes to help reduce foundation related problems. Where the recommendations in this document vary from published methods or codes, the differences represent the experience and judgment of the majority of the committee members. On sites having expansive clay, fill, and/or other adverse conditions, residential foundations shall be designed by licensed engineers utilizing the provisions of this document: (Recommended Practice for the Design of Residential Foundations). Expansive clay is defined as soil having a weighted plasticity index greater than 15 as defined by Building Research Advisory Board (BRAB) or a maximum potential volume change greater than 1 percent. This provision should also apply where local geology or experience indicates that active clay soils may be present. We propose that local and state governing bodies adopt this recommended practice.” Excerpt from: Recommended Practice for the Design of Residential Foundations, Version 1, By the Texas Section American Society of Civil Engineers © 2002
  • 3. Load-bearing values of soils For SI: 1 pound per square foot = 0.0479 kPa. a. When soil tests are required by Section R401.4, the allowable bearing capacities of the soil shall be part of the recommendations. b. Where the building official determines that in-place soils with an allowable bearing capacity of less than 1,500 psf are likely to be present at the site, the allowable bearing capacity shall be determined by a soils investigation.
  • 4. New Language City of Amarillo amendments to the 2006 IRC <ul><li>“ R401.2 Requirements. Foundation construction shall be </li></ul><ul><li>capable of accommodating all loads according to Section R301 </li></ul><ul><li>and of transmitting the resulting loads to the supporting soil. </li></ul><ul><li>Fill soils that support footings and foundations shall be </li></ul><ul><li>designed, installed and tested in accordance with accepted </li></ul><ul><li>engineering practice. Gravel fill used as footings for wood and </li></ul><ul><li>Pre-cast concrete foundations shall comply with Section R403.” </li></ul><ul><li>(added to the end of paragraph -Section R401.2) </li></ul><ul><li>Concrete foundations will be designed by registered design professional licensed in the State of Texas or constructed in compliance with The Panhandle Residential Foundation Manual </li></ul>
  • 5. The path to design residential foundations
  • 6. New for 2008 for use with the 2006 IRC
  • 7. NEW - Foundation Table
  • 8. Assumptions The Table R403.1(a) is based on the following assumptions and are considered mandatory criteria if application of these approved design standards are utilized:   1.     The generic configurations shown in this table are based on procedures recognized by the Reference (4) Wire Reinforcement Institute’s (WRI) Design of Slab-on-Ground Foundations WRI/CRSI-81 .   2.     The effective Plasticity Index (PI) of the sub-grade/fill is less than or equal to 20 when computed by the methods presented by the WRI. The determination of satisfaction this criteria shall be provided by the Building Official. The supporting foundation soils are assumed to have a minimum allowable soil bearing capacity of 1500 psf.   3.     The top 8” of subgrade or finished fill soil are processed as specified minimum 90% compaction plus or minus 5% moisture content based on the Standard Proctor (ASTM D-698). Comment - The City of Amarillo does not require, but recommends a minimum of 95% compaction plus or minus 3% based on the Standard Proctor (ASTM D-698).   4.    Uniform Loads are distributed across the interior floor slabs at 200 psf for single story, 275 psf for two story, and 350 psf for three story residential structures. Variations in above stated loadings should be taken into consideration in the final individual configuration. Structural demands imposed by concentrated application of loadings should receive enhanced foundation support.   5.    All reinforcing steel is Grade 60 (60,000 psi), and all concrete is 3000 psi @ 28 day’s cure. All reinforcement must have at least 3” of cover where exposed directly to soil.   6.    The approved foundation design standards are considered minimum standards for the City of Amarillo . Selected design dimensions and reinforcement sizes that exceed these provided standards can generally be considered acceptable.
  • 9. Amarillo 2-pour Slab-on-Grade (Typical) Brick Veneer – ISO board at base course
  • 10. Amarillo 2-pour Slab-on-Grade (Code) Brick Veneer – mortar at base course
  • 11. Interior Foundation Beam Must be installed at maximum intervals of 20’ and/or under load-bearing walls
  • 12. 2-pour Slab-on-Grade ( Energy Efficient )
  • 13. Monolithic Slab-on-Grade (Code)
  • 14. Monolithic Slab-on-Grade ( Energy Efficient )
  • 15. Typical Crawl Space
  • 16. Pier Detail
  • 17. Formed 2-Pour Slab-on-Grade
  • 18. Fireplace footing
  • 19. Basements <ul><li>Section R310.1 Amend : Emergency escape and rescue required. </li></ul><ul><li>Exception: (Add to end of paragraph) . or designed as an interior storm shelter less than 400 square feet. </li></ul>
  • 20. Trenched Basement - (Inset 6’ minimum)
  • 21. Formed Basement - (Inset 6’ minimum)
  • 22. Formed Basement – Exterior foundation includes perimeter drainage system
  • 23. CMU Basement - (Inset 6’ minimum)
  • 24. CMU Basement - Exterior foundation includes perimeter drainage system
  • 25. Accessory Buildings <ul><li>The following foundation details are for free standing, single story less than 10’ wall height, accessory to another use, limited to area of 600 square feet or less </li></ul>
  • 26. Slab-on-grade - accessory structure
  • 27. Treated floor - accessory structure
  • 28. NON-Treated floor - accessory structure
  • 29. Questions? Bernard Ray Tillery, P.E. Amarillo Testing and Engineering Thank you

Related Documents